AltManufacturing COBB Accessport V3 Vent Dock Mount for 2015+ Subaru WRX/STI

Description

This will keep your Accessport secure on your dash. We designed this part with everything in mind so you can enjoy all aspects of it. With this mount, you will be able to comfortably see your Accessport as you drive along those winding roads. The magnetic backing will add that extra layer of protection to prevent your Accessport from moving. The ODB-II cord is fed under the mount and is held in with a perfect mechanical fit. This kit does not require you to drill or cut anything in your vehicle and it will give you enough room to use the thick OEM Subaru sunshade or other sunshades.
Customer Install Video:
https://www.youtube.com/watch?v=n2NJSxzS-2g
Thanks to Luis (CWP Scoobie) for the install video.
Installation Steps:
Carefully pry up defroster vent on the left side of the dash and remove.
Feed Accessport cable from the OBD-II connector and have it come out of the opening where the vent was.
Feed Accessport cable through the mount and install included cable clamp over the end to secure the cable.
Press cable clamp into mount to lock into position. This will be tight and you will want to push on both sides until the clamp sits slightly below flush when it’s full installed.
Tilt mount to insert the left corner first and then wiggle it into place on the right side.
Tighten the M3 bolts to secure mount. This doesn’t need to be very tight, just enough that the mount won’t move.
Insert Accessport and enjoy!
Note: If you would like to remove the mount ever, use caution not to full unscrew the bolts so that the nuts and bracket don’t fall off
This mount will work for 2015+ WRX/STI
Because this product is 3D-printed, there may be small variations from one to another. 3D-printed parts may show small artifacts/blemishes as well as layer lines but this does not take away from the functional use of the part. Slight color variations may also occur.